The rule of thumb is
to clean in the same direction of travel as the bullet. That is
to clean from the chamber to the muzzle. Many of us were taught
incorrectly. We spent hours jamming patches from the muzzle to the
chamber using an old cleaning rod with a brass or plastic end to
hold the patch. Each time we did this, we introduced junk into the
receiver. This is never a good idea.
Currently, there are
cleaning kits offered that will solve this problem and they do a
really good job of cleaning a firearm. OtisŪ makes a kit that has
been adopted by our military and works very well in the field. I
have used bore snakes on the range and had good results. Bore snakes
are pieces of a rope like substance with a weight on one end that
you drop down the barrel from the chamber end. The rest of the snake
has brushes and bulk to clean the barrel. This works well on the
range or on a hunt, but does not clean anything but the barrel and
chamber. You will need several items before you begin to clean your
- A work space. My wife
doesn't like me to use the dining room table even with a gun cleaning
- A cleaning kit. There are lots of different ones on the market.
Make sure it is usable on your caliber of firearm.
- Patches made for your caliber. Try and get lint free patches.
- Cleaning solvent. We all started out using Hoppe's #9. There are
newer ones available. I really like some of the non petroleum solvents.
They will not harm the polymer based pistol frames.
- Brushes. I had to stop using my wife's tooth brush (she noticed
NOW, BEFORE YOU BEGIN,
MAKE SURE AGAIN THAT YOUR FIREARM IS UNLOADED AND THE AMMUNITION
IS NOT IN THE SAME AREA!
Disassemble your firearm
according to your owner's manual. If you do not have the manual,
go online and you will find it. This is a good time to look at the
firearm for areas of wear. The uneven accumulation a gunk may be
signs of uneven wear. Too much gunk is usually a sign of too much
lubrication and too infrequent cleaning.
- I like to run a dry
patch to identify the junk I will remove through the cleaning process.
- Apply solvent to a patch and run it thru the bore.
- Run the bore brush thru the bore several times.
- Clean the chamber area and the locking area for the bolt of a
rifle using solvent a good brush.
- Clean the action of the firearm. Pay attention to the trigger
mechanism, mag and slide release, and feed ramps.
- Now run clean patches down the bore until they come out clean.
If this seems to take too long, try another solvent patch and bore
- Continue until all is clean.
- Now is the time to run an oil patch down the bore. This is where
too much oil is introduced to the firearm. If you live in a humid
climate, you must use a preservative coating of oil to prevent rust.
If you live in the desert, like me, you can use dry lubes.
- Check the owner's manual for the preferred oil points for the
- Inspect the clean firearm as you reassemble. Now is the time to
identify pieces that may need to be replaced. Look for wear cracks
and thin spots on metal pieces.
- Functional check your firearm. If you put another mag in the weapon,
make sure it is unloaded!!
There are other things
and methods that you can use such as ultra sonic cleaners and complete
disassembly before cleaning, but these will be the subject of another
For more information
and training visit http://www.jbventuresabq.com
Remember: A clean Gun works better and is safer Article Source: